[ATMoB-discuss] FW: ?help with GSO focuser

[Motta, Mario E.,M.D.]

Hi Joe, I am not a machinist, but I am cheap. If you wnat to come by one night,
could turn it down on lathe or milling machine for you easily, But.. as your VP
for MMS, may just put you on a committee as a fee....

Mario

Rothchild, Joseph wrote:
> I recently purchased a GSO crayford focuser for my Stellarvue AT1010
refractor.  It was suposed to "fit perfectly" but the focuser adaptor OD is
about 1/16" larger than the tube ID.  Does anyone know a machinist that I could
hire to machine the anodized adaptor to fit?
>  
> Thanks.
>  
> Joseph
>
> See our web page at http://www.lahey.org for a full directory of Lahey sites,
staff, services and career opportunities.
>
> THIS MESSAGE IS INTENDED FOR THE USE OF THE PERSON TO WHOM IT IS ADDRESSED. IT
MAY CONTAIN INFORMATION THAT IS PRIVILEGED, CONFIDENTIAL AND EXEMPT FROM
DISCLOSURE UNDER APPLICABLE LAW. If you are not the intended recipient, your use
of this message for any purpose is strictly prohibited. If you have received
this communication in error, please delete the message and notify the sender so
that we may correct our records.
> _______________________________________________
> ATMoB-discuss mailing list
> ATMoB-discuss at atmob.org
> http://lists.atmob.org/mailman/listinfo/atmob-discuss
>



The information transmitted in this electronic communication is intended only for the person or entity to whom it is addressed and may contain confidential and/or privileged material. Any review, retransmission, dissemination or other use of or taking of any action in reliance upon this information by persons or entities other than the intended recipient is prohibited. If you received this information in error, please contact the Compliance HelpLine at 800-856-1983 and properly dispose of this information.